Descaling - Bosch CSG656B 2B Series Instruction Manual

Descaling

To ensure that your appliance continues to operate
correctly, it must be descaled regularly.
Descaling comprises a number of different steps. For
hygiene reasons, the descaling programme must be
run through completely before the appliance is ready
for operation again. In total, the descaling programme
runs for approx. 70–95 minutes.
Descale (approx. 55–70 minutes), then empty and
■
refill the water tank
First rinsing cycle (approx. 9–12 minutes), then
■
empty and refill the water tank
Second rinsing cycle (approx. 9–12 minutes), then
■
empty and dry the water tank
If descaling is interrupted (e.g. due to a power failure or
because the appliance is switched off), you will be
prompted to rinse the appliance twice when you switch
it back on. The appliance cannot be used until the
second rinsing cycle has finished.
The frequency with which the appliance must be
descaled depends on the hardness of the water used.
When only another five or fewer steam-assisted
operations are possible, the appliance reminds you to
descale it with a message on the display. The number
of remaining operations is displayed after the appliance
is switched on. You can therefore prepare for the
descaling in good time.
Starting
Caution!
Risk of damage to the appliance: Only use liquid
■
descalers recommended by us for the descaling
programme. The time the product needs to work
during descaling depends on the type of descaler
used. Other descalers may damage the appliance.
Descaler order no. 311 680
Descaling solution: Do not allow any descaling
■
solution or descaler to come into contact with the
control panel or other surfaces on the appliance.
This damages the surfaces. If this does happen,
remove the descaling solution immediately with
water.
If you have used a steam-assisted operation
immediately before descaling, you must first switch the
appliance off so that the residual water is pumped out
of the evaporator system.
Mix 400 ml water with 200 ml liquid descaler to
1.
make a descaling solution.
Use the ÿ On/Off button to start.
2.
Remove the water tank and fill it with descaling
3.
solution.
Once the water tank has been filled with descaling
4.
solution, push it back in again fully.
Close the control panel.
5.
Touch the Menu field.
6.
The list of operating modes is displayed.
Touch the "Cleaning" text field.
7.
Touch the "Descaling" text field.
8.
The duration of the descaling programme is
displayed. It cannot be changed.
Press the Start/Stop button l to start.
9.
The appliance is now descaled. The time counts down
in the display.
Once the cooking time has elapsed, an audible signal
sounds.
First rinsing cycle
Open the control panel.
1.
Remove the water tank, rinse thoroughly, fill with
2.
water and reinsert.
Close the control panel.
3.
Press the l Start/Stop button to start.
4.
The appliance rinses.
Once the duration has elapsed, an audible signal
sounds.
Second rinsing cycle
Open the control panel.
1.
Remove the water tank, rinse thoroughly, fill with
2.
water and reinsert.
Close the control panel.
3.
Press the l Start/Stop button to start.
4.
The appliance rinses.
Once the duration has elapsed, an audible signal
sounds.
Rinsing
Open the control panel.
1.
Empty and dry the water tank.
2.
Press the # On/Off button to switch off the
3.
appliance.
Descaling is complete and the appliance is ready for
use again.
Cleaning function en
27