Table of Contents
Advertisement
Fault
Appliance does not
heat up.
The time is not dis-
played when the ap-
pliance is switched
off.
Appliance door can-
not be opened.
Home Connect is not
working properly.
The control panel
cannot be opened.
The appliance re-
quests descaling
without the counter
appearing in ad-
vance.
The appliance
prompts you to rinse
it.
"Fill water tank" ap-
pears in the display
even though the wa-
ter tank has been
filled.
Cause and troubleshooting
Demo mode is switched on.
1.
Briefly disconnect the appliance from the power supply by switching the circuit breaker in
the fuse box off and then on again.
2.
Switch off demo mode in the basic settings within approx. 5 minutes.
→ "Changing the basic settings", Page 26
There has been a power cut.
▶
Open and close the appliance door once after a power failure.
a The appliance is checked and is ready to use.
Basic setting has been changed.
▶
Change the basic setting for the time display.
→ "Basic settings", Page 25
The cleaning function locks the appliance door;
▶
Allow the appliance to cool down until
→ "Pyrolytic activeClean cleaning function", Page 31
The childproof lock locks the appliance door.
▶
Deactivate the childproof lock using the setting ring.
→ "Childproof lock", Page 25
You can switch off the lock in the basic settings.
→ "Basic settings", Page 25
Different causes are possible.
▶
Go to www.home-connect.com.
The circuit breaker in the fuse box has tripped.
▶
Check the circuit breaker in the fuse box.
There has been a power cut.
▶
Check whether the lighting in your room or other appliances are working.
Malfunction
1.
Call the after-sales service.
→ "Customer Service", Page 41
2.
If there is water in the water tank, empty the water tank:
Open the appliance door.
‒
Grip on the right and left below the control panel.
‒
Slowly pull out the control panel and push it upwards.
‒
The set water hardness range is too low.
1.
Descale the appliance.
→ "Descaling", Page 33
2.
Check the water hardness and set this in the basic settings.
→ "Basic settings", Page 25
During the descaling, the power supply is interrupted or the appliance is switched off.
▶
Rinse the appliance.
→ "Descaling", Page 33
The water tank has not clicked into place.
▶
Insert the water tank correctly so that it engages in the holder.
→ "Filling the water tank", Page 17
lights up in the display.
goes out in the display.
Troubleshooting en
39
Advertisement
Table of Contents
