Wiring - Empire Comfort Systems EBL74-1 Owner's Manual

Fireplace Installation

Wiring

WARNING: To reduce the risk
of fire, electric shock or injury to
persons, always use a licensed
electrician.
WARNING: Ensure that the
circuit on which the fireplace is
to be installed has the power
cut off at the service panel
until installation is complete.
1. Carefully remove the electrical
cover bracket from the back of
the fireplace by removing the
three retaining screws. (Figure 2)
2. Leaving a minimum of 3 in.
(7.6 cm) of slack, route the
power supply through a cable
clamp (not included) and the
hole in the electrical cover
Wiring Diagram
SWITCH BOARD
LED STRIPS
(RGB) - MEDIA
DISPLAY / CONTROL BOARD
8
RELAY BOARD
LED STRIPS
(RGB) - FLAME
FLICKER MOTOR
M
THERMISTOR
AC/DC
ADAPTER
FLAME LED STRIPS (AMBER)
bracket.
3. Remove the cover off of the
unit at the front to access the
wire connections. (Figure 3)
Figure 2
Screws
Electrical Cover Bracket
M
BLOWER MOTOR
ELEMENTS
THERMAL
LED DRIVER
BOARDS
CUTOUT
www.empirecomfort.com