Creating Pptp, L2Tp, L2Tp Dual Stack, Or L2Tp Over Ipsec Wan Connection - D-Link DWR-921 User Manual

DWR-921 4G LTE Router
User Manual

Creating PPTP, L2TP, L2TP Dual Stack, or L2TP over IPsec WAN Connection

On the connection creation page, in the General Settings section, select the relevant value from
the Connection type drop-down list and specify the needed values.
Figure 76. The page for creating a new PPTP connection. The General Settings section.
Parameter
Connection name
Enable connection
NAT
NATv6
Ping
General Settings
A name for the connection for easier identification.
Move the switch to the right to enable the connection.
Move the switch to the left to disable the connection.
If the switch is moved to the right, the network address translation
function for IPv4 is enabled. Do not disable the function unless your
ISP requires this.
For the L2TP Dual Stack type only.
If the switch is moved to the right, the network address translation
function for IPv6 is enabled. Do not disable the function unless your
ISP requires this.
For the PPTP, L2TP, and L2TP Dual Stack types only.
If the switch is moved to the right, the router responds to ping
requests from the external network through this connection. For
security reasons, it is recommended to disable this function.
Page 88 of 255
Configuring via Web-based Interface
Description