Wps - D-Link DWR-921 User Manual

DWR-921 4G LTE Router
User Manual

WPS

On the Wi-Fi / WPS page, you can enable the function for configuration of the WLAN and select a
method for connection to the WLAN.
The WPS function helps to configure the protected wireless network automatically. Devices
connecting to the wireless network via the WPS function must support the WPS function.
!
The WPS function allows adding devices only to the basic wireless network of the router.
Before using the function you need to configure one of the following authentication types:
!
Open with no encryption, WPA-PSK , WPA2-PSK , or WPA-PSK/WPA2-PSK mixed
with the AES encryption method. When other security settings are specified, controls of
the WPS page are not available .
You can activate the WPS function via the web-based interface or the hardware WPS button on the
cover of the device.
To activate the WPS function via the hardware button, move the Enable WPS function with
hardware button switch to the right. Then, with the device turned on, press the WPS button and
release it. The WLAN LED should start blinking slowly. In addition, upon pressing the button, the
wireless interface of the device is enabled if it was disabled before.
If you want to disable activating the WPS function via the hardware button, move the Enable
WPS function with hardware button switch to the left and make sure that the WPS function is
not activated via the web-based interface.
To activate the WPS function via the web-based interface, click the ENABLE WPS button.
Figure 124. The page for configuring the WPS function.
Page 151 of 255
Configuring via Web-based Interface