D-Link DWR-921 User Manual page 146

DWR-921 4G LTE Router
User Manual
Parameter
Clients isolation
Enable guest network
In the Security Settings section, you can change security settings of the wireless network.
By default, the WPA2-PSK network authentication type of the wireless network is specified. WPS
PIN from the barcode label is used as the network key.
Figure 119. Network authentication types supported by the router.
The router supports the following authentication types:
Authentication type
Open
WEP
WPA
WPA-PSK
WPA2
WPA2-PSK
WPA/WPA2 mixed
Move the switch to the right to forbid wireless clients of this
wireless network to communicate to each other.
This function is available for the additional network. Move the
switch to the right if you want the devices connected to the
additional network to be isolated from the devices and resources of
the router's LAN.
Open authentication (with WEP encryption for wireless network
modes not supporting 802.11n).
Authentication with a shared key with WEP encryption. This
authentication type is not available when a mode supporting
802.11n devices is selected from the Wireless mode drop-down
list on the Wi-Fi / Basic Settings page.
WPA-based authentication using a RADIUS server.
WPA-based authentication using a PSK.
WPA2-based authentication using a RADIUS server.
WPA2-based authentication using a PSK.
A mixed type of authentication. When this value is selected, devices
using the WPA authentication type and devices using the WPA2
authentication type can connect to the wireless network.
Page 146 of 255
Configuring via Web-based Interface
Description
Description