Table of Contents
Advertisement
Sensor Scan Time
For all models: 55 microseconds per beam plus processing time. The processing
time is dependent on the scan analysis and the number of active outputs. This
timing assumes a straight scan, continuous, and TBB mode.
MAC-1, MACN-1 & MACP-1: 1 millisecond processing time.
MACV-1 & MACI-1: 1.5 milliseconds processing time.
MAC16N-1 & MAC16P-1: 2.3 to 7 milliseconds processing time.
Construction
Polycarbonate
Environmental Rating
NEMA 1 (IP20)
Operating Conditions
−20 °C to +70 °C (−4 °F to +158 °F)
95% maximum relative humidity (non-condensing)
Certifications
3.4 Dimensions for the Controller
7.4 mm
(0.29")
60.8 mm
(2.40")
7.1 mm
(0.28")
100.0 mm
3.94"
85.3 mm
3.36"
35.0 mm
Din mounting slot
Slot for screws (2)
M3.5 x 0.6 mm (2)
Din mounting tab
(supplied)
www.bannerengineering.com - Tel: 763.544.3164
A-GAGE
Required Overcurrent Protection
WARNING: Electrical connections must be made by
qualified personnel in accordance with local and
national electrical codes and regulations.
Overcurrent protection is required to be provided by end product application
per the supplied table.
Overcurrent protection may be provided with external fusing or via Current
Limiting, Class 2 Power Supply.
Supply wiring leads < 24 AWG shall not be spliced.
For additional product support, go to www.bannerengineering.com.
Supply Wiring (AWG)
20
22
24
26
28
30
110.0 mm
(4.33")
Combo Head (Phillips/Slotted Screws
M3.5 x 0.6 mm x 14 mm (2 ) (#6 x 0.5" equivalent) (supplied)
M3.5 Washers (2) (#6 equivalent) (supplied)
M3.5 mm x 0.6 mm Nuts (2) (#6 equivalent) (supplied)
(1.38")
Recommended torque is
16-20 in -lbs on mounting screws
®
®
MINI-ARRAY
Measuring Light Screen System
Required Overcurrent Protection (Amps)
5.0
3.0
2.0
1.0
0.8
0.5
75.0 mm
(2.95")
9
Advertisement
Table of Contents
