Operating Instructions; Status Indicators For The Mini-Array Sensors; Status Indicators For The Macx-1 Series Controllers - Banner A-GAGE MINI-ARRAY MAC-1 Instruction Manual

6 Operating Instructions

6.1 Status Indicators for the MINI-ARRAY Sensors

Note: Status indicators appear to "freeze" if the controller has been configured for the Gate or the Host Mode and there is no
signal to cause a scan update.
Red On Red Off Red Flashing
X
X
Green
Green On Amber On
Flashing
X
X
X
X

6.2 Status Indicators for the MACx-1 Series Controllers

Indicator
Output 1 (labeled OUT1, V out, I out,
OUT or OUT 1 depending on model)
Alarm
Gate
Figure 6. Receiver LEDs
Emitter Status
Emitter has power and is functioning properly.
Emitter failure. The controller's red DIAG 3 indicator should come ON when the red LED on the emitter goes OFF. Run
the Diagnostics software to determine the cause of the emitter failure.
Emitter has momentarily lost and then regained power and is waiting for activity from the controller. This can occur in
X Gate or Host Mode after the emitter has been temporarily unplugged and then reconnected, but before the emitter
receives its next gating command.
Red On Receiver Status
Receiver is in proper alignment and no beams are broken.
Receiver has momentarily lost and then regained power and is waiting for activity from the controller.
This can occur in Gate or Host Mode after the receiver has been temporarily unplugged and then
reconnected, but before the receiver receives its next gating command.
Marginal alignment. The MINI-ARRAY System continues to operate normally, but the amber comes ON as
X an early warning of possible signal loss due to gradual sensor misalignment and/or dirt buildup on the
lenses, etc.
X Either one or more beams are blocked or the sensor is misaligned if the screen is clear of objects.
X X Receiver failure. Run the Diagnostics software to determine the cause of the receiver failure.
LED Color Function
Models MAC-1, MACP-1, MACN-1, MACV-1, MACI-1: displays the status of Output #1
Red
Models MAC16N-1 and MAC16P-1: displays the status that at least one output is active
Models MAC-1, MACP-1, MACN-1, MACV-1, MACI-1: displays the status of Output #2. Output #2 may be
assigned to an Analysis Mode or may be used as a system diagnostics Alarm, or as a Trigger alarm for gating
Red
another MINI-ARRAY System
Models MAC16N-1 and MAC16P-1: displays the status of Output #16
Red Displays the status of the Gate input
www.bannerengineering.com - Tel: 763.544.3164
® ®
A-GAGE MINI-ARRAY
Green
Red
Amber
Measuring Light Screen System
25