Table of Contents
Advertisement
U
PDATING THE
When performing the software update, use a set of fully charged batteries or the AC adapter (sold
separately). When using the AC adapter, be sure not to inadvertently disconnect the camera during
the software updating procedure, otherwise the camera may be permanently damaged. The camera
memory and settings are all reset when the update software is installed.
(C)
(D)
Updating Notes:
• After updating, delete the update files from the CF card; format the card or remove the files using
a computer. If the files remain on the card, the update procedure may repeat.
• If the update was not performed correctly, or an error occurred during the update procedure, an
error message appears. Turn the camera off and remove the batteries or disconnect the AC
adapter. Repeat the procedure from step 1.
• If any other software version number is displayed or the camera does not work properly, repeat the
installation procedure.
• This software update can only be used for versions ending with the letter "u" or "e." The update
will not work with software ending in any other letter.
C
F
AMERA
IRMWARE
1. With the camera off, insert the prepared CF
card.
2. Turn the camera on, and press the playback
button (C).
3. When the update confirmation screen
appears, select "Yes" and press the central
button of the controller to begin the firmware
update. This process should take about two
minutes.
4. When the complete message appears, turn
the camera off and remove the CF card.
5. Turn the camera on and press the menu
button (D).
6. Press the display button. Confirm that ver.
1.10 is displayed. The version number is
followed by "e" or "u" denoting the product
region (E).
7. Press the central button of the controller to
close the screen.
8. Reset the camera using the recording-mode
reset function. See page 64 in the camera
manual.
- 7 -
(E)
MAXXUM 7D
MAXXUM 7D
Ver. 1.10e
OK
Advertisement
Table of Contents
