Exchange Procedure - Konica Minolta PagePro 1380 MF Warranty Exchange Manual

Introduction
Thank you for contacting a technical support representative to obtain
information about returning your PagePro 1380 MF for warranty exchange.
Follow these instructions very carefully.
If you need additional assistance, refer to the General Information Guide
(included with the original all-in-one) or printer.konicaminolta.com for world-
wide sources of service and support.
Attention
Failure to follow these instructions could result in voiding your
warranty.

Exchange Procedure

Each of these steps is explained in detail in this guide.
1
Unpack the exchange all-in-one, and unlock the scan-
ning unit.
2
Prepare the original all-in-one—Turn it off, unplug the
power cord and USB cable, remove the output tray, and
remove the media and media tray.
3
If you have installed an optional automatic document
feeder on the original all-in-one, move it to the
exchange all-in-one.
4
Move the imaging cartridge from the original all-in-one
to the exchange all-in-one.
5
Finish setting up the exchange all-in-one—attach the
the media tray and fill it with paper, attach the output
tray, plug it the power cord and USB cable, and turn on
the all-in-one.
6
Lock the scanning unit on the original all-in-one, repack
it, and then call the shipper for pickup.
Introduction
See page 2.
See page 3.
See page 5.
See page 7.
See page 8.
See page 10.
1