Exchange Procedure - Konica Minolta PagePro 1390 MF Warranty Exchange Manual

Introduction
Thank you for contacting a technical support representative to obtain
information about returning your PagePro 1390 MF for warranty exchange.
Follow these instructions very carefully.
If you need additional assistance, refer to the General Information Guide
(included with the original all-in-one) or printer.konicaminolta.com for world-
wide sources of service and support.
Attention
Failure to follow these instructions could result in voiding your
warranty.

Exchange Procedure

Each of these steps is explained in detail in this guide.
1
Unpack the exchange all-in-one, and unlock the scan-
ning unit.
2
Prepare the original all-in-one—turn it off, disconnect
the USB cable, unplug the power cord, disconnect the
telephone line(s) and ADF cable, remove the output
tray, remove the media and media tray, and then
remove the input tray and media stopper from the auto-
matic document feeder (ADF).
3
Move the imaging cartridge from the original all-in-one
to the exchange all-in-one.
4
Finish setting up the exchange all-in-one—attach the
input tray and media stopper to the ADF, attach the
media tray and fill it with paper, attach the output tray,
connect the ADF and USB cables, connect the tele-
phone line(s), plug in the power cord and USB cable,
and turn on the all-in-one.
5
Lock the scanning unit, repack the original all-in-one,
and then call the shipper for pickup.
Introduction
See page 2.
See page 3.
See page 6.
See page 7.
See page 12.
1