Cleaning The Separator Roller - Kodak Ngenuity 9090DB Operator's Manual

Over time the separator roller will become dirty and may begin to cause multifeeds. To prevent
feeding problems, BBH recommends cleaning the separator roller every 10,000 pages fed or as
needed. Different document types, the condition of the documents being scanned, and the
volume of scanning may require more frequent cleanings.
Always remove the separator roller from the scanner for cleaning to ensure best results.
Item(s) Needed
• Cleaning Wipes
To clean the separator roller, perform the following:
1. Power OFF the scanner (see 1.4.2 Scanner Back,
2. Open the scanner's transport cover (see 1.4.1 Scanner Front,
and "Transport Cover Release Levers" on page 7)
3. Open the separator roller door by pulling the door towards the front of the scanner, exposing
the separator roller
4. Lift the separator roller out of the scanner
5. Using the Cleaning Wipes, scrub the separator roller in a side
to side (<------->) motion, taking care to rotate the roller, clean-
ing the entire surface
6. Install the clean, separator roller back into the scanner
- Hold open the separator door
- Note the two ends of the separator roller, particularly the
shaft that protrudes from each side; one is flat, the other
rounded. Position the separator roller so that the flat end
is on the right side (as viewed from the front of the scan-
ner)
66
C
LEANING THE
"Power Switch" on page
-Place the roller so that the shaft on each side of the
roller rests within the slots in the pivot assembly (pivot
assembly is stationary inside the scanner), taking care
that the flat end of the shaft on the right side sits flush
within the plastic bracket.
-Close the separator door to confirm the proper
placement of the separator roller
7. Clean the skimmer rollers (see
mer Rollers" on page 61)
S R
EPARATOR
11)
"Transport Cover" on page 7
Flat end
Round end
"Cleaning the Skim-
S008769 Rev A
OLLER