Husqvarna HUV4420 Service Manual page 73

ACCELERATOR AND BRAKE PEDAL ASSEMBLIES
4. Secure the park brake cable release handle to the dashboard, and loosely install a jam nut.
5. Install the instrument panel. See Instrument Panel Installation on page 4-4.
6. Install the dashboard. See Dashboard Installation on page 4-4.
7. Connect the battery cables, positive (+) cable first, and tighten the hardware to 12 ft-lb (16 N·m). Coat
terminals with Battery Terminal Protector Spray (Husqvarna 603 00 00-03).
PARK BRAKE CABLE INSTALLATION
1. Use a small, stiff brush to remove all dirt and debris from the ratchet teeth (1) (Figure 6-5, Page 6-4).
2. Feed the eye end of the cable through the pedal bracket until the cable sheath ferrule is secure in the
pedal bracket and the tines secure the cable (Figure 6-5, Page 6-4).
3. Install the eye of the cable on the park brake assembly pin, and install the C-clip.
4. Secure the pedal return spring from the bracket frame to the park brake assembly pin.
PARK BRAKE CABLE ADJUSTMENT
1. Release the park brake, and advance the conical nut until slack is removed from all cables.
2. Push the park brake pedal until the pedal is firm and the brakes are locked.
3. With the vehicle on flat ground and the Forward/Reverse handle in the NEUTRAL position, push the vehi-
cle by hand. If the wheels move, tighten the conical nut until the vehicle does not move and the brake
pedal locks the brakes at two to three clicks.
NOTE: The pedal must not travel more than three clicks to a brake lock position.
4. If the pedal travels more than three clicks to a brake lock position, complete steps 4.1 and 4.2.
4.1. Advance the conical nut on the threaded cable end at the equalizer bracket until the park brake
pedal locks the brakes at two to three clicks (Figure 6-6, Page 6-5).
4.2. Tighten the jam nut to 55 in-lb (6 N·m).
Figure 6-6 Park Brake Adjustment Nuts
2005 HUV4420 Gasoline and HUV4420-D Diesel Vehicle Maintenance and Service Manual
6
Park Brake Pedal
Page 6-5