Husqvarna HUV4420 Service Manual page 26

3
GENERAL INFORMATION
Returning the Stored Vehicle to Service, Continued:
5. Place the Forward/Reverse handle in the NEUTRAL position. Crank the engine until fuel is pumped into
the carburetor (gasoline vehicles) and the fuel lines and the engine starts. Turn the engine off. See fol-
lowing NOTE.
NOTE: Due to the oil added to the engine in preparation for storage, the engine may smoke excessively for
a short time when it is run for the first time after storage.
6. Perform the Pre-Operation and Daily Safety Checklist. See the Pre-Operation and Daily Safety
Checklist in the vehicle owner's manual.
VIEWED FROM SELECTOR
Figure 3-4 Fuel Shut-Off Valve – Open Position
PARTIALLY CLOSED
VIEWED FROM SELECTOR
Figure 3-6 Fuel Shut-Off Valve –
Partially Closed Position
Page 3-4 2005 HUV4420 Gasoline and HUV4420-D Diesel Vehicle Maintenance and Service Manual
FULL OPEN (ON)
POSITION
SIDE OF VALVE
POSITION
SIDE OF VALVE
CLOSED (OFF) POSITION
(SELECTOR IS ALIGNED
WITH OFF MARKINGS ON THE SIDES OF VALVE)
OFF
VIEWED FROM SELECTOR
SIDE OF VALVE
Figure 3-5 Fuel Shut-Off Valve – Closed Position
Storage
OFF