Front Park Brake Cable Removal - Husqvarna HUV4420 Service Manual

5
HYDRAULIC AND PARK BRAKE SYSTEMS
Right Rear Cable Installation, Continued:
Figure 5-24 Air Filter and Park Brake Cable Clamp
Left Rear Cable Installation
1. Install the caliper end of the cable into the brake caliper arm (Figure 5-22, Page 5-25).
2. Slide the sheath ferrule through the hole in the caliper mounting bracket.
3. Install a C-clip to hold the cable ferrule in place.
4. Route the cable to the inside of the air intake hose.
5. Secure the cable end to the equalizer bracket. See Equalizer Installation on page 5-27.

FRONT PARK BRAKE CABLE REMOVAL

1. Chock the rear wheels, and release the park brake.
2. Remove the dashboard. See Dashboard Removal, Section 4, Page 4-4.
3. Remove the spring from the driver side equalizer adjustment rod (Figure 5-23, Page 5-25).
4. Remove the nuts from the threaded adjustment rod on the cable end.
5. Remove the C-clip and washer from the cable at the park brake assembly, and remove the cable eye
from the park brake assembly (Figure 5-26, Page 5-27).
6. Tie a heavy nylon string to the threaded adjustment rod, and remove the cable from the vehicle body at
the park brake assembly. Allow the nylon string to travel under the body to the park brake pedal. See fol-
lowing NOTE.
NOTE: Using a heavy nylon string will help route a new park brake cable through the vehicle body.
Equalizer Removal
1. Chock the wheels, and release the park brake.
2. Remove the spring from the driver side equalizer adjustment rod (Figure 5-25, Page 5-27).
3. Remove the nuts from the threaded adjustment rod on the cable end.
4. Remove the rear park brake cables from the equalizer, and remove the equalizer.
Page 5-26 2005 HUV4420 Gasoline and HUV4420-D Diesel Vehicle Maintenance and Service Manual
Park Brake System