Installing The Rear Bumper - Toro ProLine H800 Setup Instructions

Figure 6
Hook installed
1. Right side
g315988
2. Left side
4

Installing the Rear Bumper

Parts needed for this procedure:
1 Rear bumper
4 Bolt
8 Flat washer
4 Locknut
4 Cable ties
Procedure
1. Remove the hardware from the rear bumper
(Figure 7).
2. Install the rear bumper under the hopper with
the previously removed hardware
3. Connect the wire harness to the machine
harness.
4. Verify that the left and right turn lights are
hooked up correctly by using the turn signal. If
needed, change the connections.
5. Use the cable ties to fasten the wire harness to
the rear bumper.
1. Rear bumper
2. Bolt
5
(Figure
Figure 7
3. Washer
4. Locknut
7).
g316095