Installing The Latch - Toro ProLine H800 Setup Instructions

2
Installing the Hopper Door
Parts needed for this procedure:
6 Flat washer
2 Bolt
2 Locknut
Procedure
1. Remove the hardware from the brackets on the
hopper.
2. Install the hopper door to the hopper with the
previously removed hardware; refer to
1. Hopper door
2. Bolt
Figure
Figure 2
3. Washer
4. Locknut
3

Installing the Latch

Parts needed for this procedure:
1 Hook
1 Spacer
2 Long bolt
1 Short bolt
3 Flat washer
1 Rod connector
1 Spring
2 Bushing
2.
3 Flange nut
2 Locknut
Procedure
1. Install the hook and spacer to the hopper with
a long bolt, flat washer, flange nut, spring, and
locknut (Figure
g315991
3
3).