Setting Utc Offset; Selecting Data Band; Selecting Packet Transfer Rate - Kenwood TM-D700A Instruction Manual

Setting UTC Offset

1 Press [MNU] to enter Menu mode.
2 Press [c c c c c ]/ [d d d d d ] to select "RADIO (1–)", then press
[OK].
3 Press [c c c c c ]/ [d d d d d ] to select "TNC (1–6–)", then press
[OK].
4 Select Menu 1–6–5 (TIME ZONE), then press
[OK].
5 Press [c c c c c ]/ [d d d d d ] to select the appropriate UTC
offset, then press [OK].
• The selectable range is from +12:00 to –12:00 in
steps of 30 minutes.
6 Press [MNU] to exit Menu mode.

SELECTING DATA BAND

On this transceiver you can select data band for APRS
mode independent of the selection (in Menu 1–6–1) for
Packet mode. Access Menu 3–I (DATA BAND) and
select band A or B as the data band for receiving or
transmitting APRS packets. The default is band A. "
indicates the current data band.
Note: In Menu 3–I, the selection switches among A, B, A:TX B:RX, and
A:RX B:TX. Select A:TX B:RX or A:RX B:TX if APRS networks which use
two separate frequencies become available in the future.

SELECTING PACKET TRANSFER RATE

The default APRS packet transfer rate set on the built-in
TNC is 1200 bps which is the standard among the
current APRS networks. If APRS networks which use
9600 bps transfer rate become available in the future,
access Menu 3–J (PACKET SPEED) and select "9600
bps".
"
4
13