Configuring Abnormality Settings; Configuring For Sd Card Event Settings - Honeywell Performance Series User Manual

Performance Series IP Camera Software Configuration Guide
Advanced
Record
Record Delay
Relay-out
Alarm Delay
Send Email
6. Click Save to apply the settings.

Configuring Abnormality Settings

Configuring for SD Card Event Settings

Go to Setup  Video Analytics 
SD card events include No SD Card, SD Card Error, and Capacity Warning.
62
time after the camera detects face.
Quality Priority: Repeatedly compare the captured face to the faces in
the armed face database and capture the most similar face image and
send the alarm. It is recommended to use this mode in access control
scene.
Click Advanced to set the optimized time.
Snapshot Angle Filter: Set snapshot angle to be filtered during
•
the face detection.
Snapshot Sensitivity: Set snapshot sensitivity during the face
•
detection. It is easier to detect face with higher sensitivity.
Quality Threshold: Set snapshot quality level during the face
•
detection.
Optimized Time: Set a time period to capture the clearest picture
•
after the camera detects face.
If Record is enabled, a scene change event can activate recording.
The system will wait for the specified time before it begins recording.
Select from 10s to 300s.
Select the Relay-out check box, and when alarm is triggered, the
system interacts with the linked alarm devices.
The Alarm linkage keeps running for the configured time after alarm is
ended.
When enabled, the system sends an email alert when an alarm occurs.
Email settings must be configured in Setup  Network Setup  SMTP
(Email). See Configuring SMTP (Email) Settings
the snapshot to be attached to the email notification, the Attachment
check box must be selected.
Abnormality
on page 39, and for
 SD Card.