Configuring Face Detection; Table 7-5 Scene Change Configurations; Configuring Face Detection Events - Honeywell Performance Series User Manual

Performance Series IP Camera Software Configuration Guide
6. Click Draw Target at the right side of Pixel Counter, and then press and hold the left
mouse button to draw a rectangle, the Pixel Counter then displays its pixel.
7. Set rule parameters for IVS.

Table 7-5 Scene Change Configurations

Parameter
Period
Direction
Target Filter
Effective object
Record
Record Delay
Relay-out
Alarm Delay
Send Email
Snapshot
8. Click Save.

Configuring Face Detection

This function is only supported by
H4W4PER3V/H4W4PER2V/HBW4PER1V/HBW4PER2V/HEW4PER3V/HEW4PE
Note
R2V/H2W4PER3V/H4W8PER2V/HBW8PER2V/HEW8PER2V/H4W8PER1V/HBW
8PER1V.
Go to Setup  Video Analytics Face Detection.
60
Function
The IVS function is activated during the specified period.
See Configuring the Alarm Period
You can configure up to six periods per day. Select a date. If you do
not select a date, the current setup will be applied to today only.
You can select All to apply the alarm period to the whole week.Click
Save to exit.
Set the direction of rule detection.
• When setting tripwire, select A->B, B->A, or A<->B.
• When setting intrusion, select Enters, Exits, or Enter&Exit.
Select the check box to enable the smart Tripwire/ Intrusion function.
Includes Human and Motor vehicle. When you select Human, the
camera will detect human and non-motorized vehicle.
If Record is enabled, a scene change event can activate recording.
The system will wait for the specified time before it begins recording.
Select from 10s to 300s.
Select the Relay-out check box, and when alarm is triggered, the
system interacts with the linked alarm devices.
The Alarm linkage keeps running for the configured time after alarm is
ended.
When enabled, the system sends an email alert when an alarm occurs.
When enabled, the system attaches a snapshot to an email alert when
an alarm occurs.
on page 51.