Table of Contents
Advertisement
5. Press the
button to start the function.
The duration and temperature
parameters cannot be changed by the
user.
At the end,
and a beep is activated.
6. Press the
touch button on the control
panel to exit the function.
Programmed Vapor Clean cycle
It is possible to program the Vapor Clean
function start time, like any cooking function.
1. After selecting the Vapor Clean function,
press the
button.
The
and
indicator lights on the display
flashes.
2. press the
and
the control panel to set the function end time.
3. Press the
button to confirm.
The appliance waits until the set start time to start
the Vapour Clean function.
Reservoir draining
Before draining the reservoir, wait for
the oven to cool down, leaving the
door open. To make sure that the water
remaining in the reservoir is not too hot,
wait at least 40 minutes.
After Vapor Clean function:
1. Open the door
2. Place the deep pan on the second shelf
from the bottom. Push it against the rear wall
of the oven cavity.
86 - CLEANING AND MAINTENANCE
is displayed and flashes
touch buttons on
3. On the display, press the
button flashes..
The appliance suggests the Drain reservoir
function
.
4. Press the
button to confirm the function.
5. Press the
button again to start the
function.
The water starts to flow into the deep pan from
the drain pipe on the right side of the rear wall
of the oven cavity.
6. Wait for the end of the drain flow.
At the end the appliance makes a beep and the
display shows
7. Press the
touch button on the control
panel to exit the function.
button. The
.
91477A631/A
Advertisement
Table of Contents
