Braun Multiquick 7 Manual page 6

Kneading
(Picture section A a–i also applies for the
usage of the kneading tool.)
The kneading tool (6) is ideally suited for
kneading different dough types like yeast
dough or pastry (max. 250 g flour).
• Place the kneading tool into the bowl (3).
• First fill the flour into the bowl, then add the
other ingredients except liquids.
1 1
r r
S u g a S u g a
1. 1.
• Then turn the motor on and add liquids.
2 2
• Please let the motor unit cool down for
10 min. after a kneading time of max. 1 min.
3 3
max. max.
1 min. 1 min.
10 min. 10 min.
Yeast dough (for pizza, bread, cake)
Max. 250 g flour plus ingredients. Speed «15»,
maximum kneading time: max. 1 minute.
First fill the flour into the bowl, then add the
other ingredients except liquids. Add liquids
through the filling tube while the motor is
running.
Pastry (for quiche, cake)
Max. 250 g flour plus ingredients. Speed «15»,
maximum kneading time: max. 1 minute.
First fill the flour into the bowl, then add the
other ingredients. For good results, do not use
warm, soft butter. Stop kneading shortly after
dough has formed a ball. Dough will become
too soft from excessive kneading.
Slicing/shredding
Using the slicing tool (7a), you can slice e.g.
cucumbers, onions, mushrooms, apples,
6
2. 2.
(see picture section B)
carrots, radishes, raw potatoes, courgettes,
cabbage. Using the shredding tools (7 b-c),
you can shred e.g. apples, carrots, raw
potatoes, beetroot, cabbage, cheese (soft to
medium).
a) Place a tool (7a-c) into the tool holder (7)
and snap into position. Place the tool
holder on the centre pin of the bowl and
give it a turn to lock into place.
b) Attach the lid (2) onto the bowl with the
interlock (2c) positioned next to the bowl
handle. To lock the lid, turn it clockwise so
that the interlock engages with a «click»
above the handle.
c) Insert the motor part into the coupling until
it locks. Select speed settings according to
recommendations in picture (j).
d) Fill the food to be processed into the filling
tube. Never reach into the filling tube when
the appliance is switched on. Always use
the pusher (1) to feed in food.
e) Press switch (b) or (c) on the motor part to
operate.
f) After use, press buttons (d) to remove the
motor part.
g) Pressing the lid interlock (2c), turn the lid
counter-clockwise to unlatch it and lift it up.
h) Take out the tool holder before removing
the processed food. To remove the tool,
push it up at the end that protrudes at the
bottom of the tool holder.
Cleaning
Clean the motor part (a) with a damp cloth
only. The lid (2) can be cleaned under running
water, but do not immerse it in water, nor clean
it in a dishwasher. All other parts can be
cleaned in a dishwasher.
When processing foods with colour (e.g.
carrots), the plastic parts of the appliance may
become discoloured. Wipe these parts with
vegetable oil before cleaning them.
Subject to change without notice
For guarantee terms please refer to the use
instructions of the basic unit.