Advertisement
TH-42PA20E / TH-42PA20B
b. Remove coupler (CC24) connected to the C2 module.
c. Remove C2 module fastening screws (×4), and remove
the C2 module.
15. Remove the shield plate (bottom).
a. Remove the shield plate (bottom) fastening screws (×7),
and remove the shield plate (bottom).
16. Remove the rear cover mounting brackets.
a. Remove the rear cover mounting bracket (top) fastening
screws (×4), and remove the rear cover mounting
bracket (top).
b. Remove the rear cover mounting bracket (left, right)
fastening screws (×4 each), and remove the rear cover
mounting brackets (left and right).
c. Remove the fastening screws (×2) holding the front
frame and plasma panel.
17. Remove the front frame.
a. Leaving the front glass and front board unit attached to
the front frame, pull the bottom of the front frame
forward, lift, and remove.
18. Remove stand brackets.
a. Remove the plasma panel section from the servicing
stand and lay on a surface such as a table (covered),
with the plasma panel surface facing downward.
Spread a soft cloth or similar on the table for protection,
so the panel surface is not scratched.
b. Remove the stand bracket (left, right) fastening screws
(×4 each) and remove the stand brackets (left, right).
12
Advertisement
