Sony DCR-HC15 Operation Manual page 60

Dubbing only desired scenes – Digital program editing
Step 2: Setting the VCR to operate
When you are connecting the camcorder and VCR using the A/V connecting cable, the
signal is emitted from the infrared rays emitter of your camcorder to the remote sensor
on the VCR to control the VCR.
The POWER switch should be set to
Operate by touching the panel.
(1) Turn the power of the connected VCR on. If the VCR has an input selector, set
(2) Press FN to display PAGE1.
(3) Press MENU to display the menu.
(4) Select VIDEO EDIT in
(5) Press EDIT SET.
(6) Select CONTROL, then press EXEC.
(7) When connecting with the A/V connecting cable, select IR, then press EXEC.
(8) Select IR SETUP, then press EXEC.
(9) Select the IR SETUP code of your VCR, then press EXEC. Check the code in
60
it to input.
When you connect a video camera recorder, set its power switch to VCR/VTR.
When connecting with the i.LINK cable, select i.LINK, press EXEC, then go to
"Step 3: Adjusting the synchronization of the VCR" on page 63.
"About the IR SETUP code" (p. 62).
V I DEO ED I T
MARK START
I N
TOTAL 0:00:00:00
SCENE 0
V I DEO ED I T
ED I T SET
CONTROL
ADJ TEST
"CUT - I N"
"CUT -OUT"
I R SETUP
PAUSEMODE
I R TEST
.
, then press EXEC (p. 85).
0:32:30:14
ED I T
UNDO
SET
END
END
I R
i. L I NK
EXEC RET.
END
V I DEO ED I T
ED I T SET
CONTROL I R
ADJ TEST
"CUT - I N"
"CUT -OUT"
I R SETUP
PAUSEMODE
I R TEST
EXEC RET.
END
V I DEO ED I T
ED I T SET
CONTROL
ADJ TEST
"CUT - I N"
"CUT -OUT"
I R SETUP 3
PAUSEMODE
I R TEST
EXEC RET.