Table of Contents
Advertisement
2. Insert and tighten the two screws using the Phillips #2 screwdriver.
Figure 79. Installing screws
Install the system in the cabinet
This procedure is used to install the system in the cabinet.
About this task
WARNING:
The system is heavy and should be installed in a cabinet by two people. To avoid personal injury
and/or damage to the equipment, do not attempt to install the system in a cabinet without a mechanical lift
and/or help from another person.
Steps
1. At front of the cabinet, pull the inner slide rails out of the cabinet until they lock into place.
Figure 80. Pull the inner rails out of the cabinet
2. Locate the rear rail standoff on each side of the system. Position the system above the rails and lower the rear rail standoffs
into the rear J-slots on the slide assemblies.
3. Rotate the system downward until all the rail standoffs are seated in the J-slots.
142
Replace the Rail Kit
Advertisement
Table of Contents
