Table of Contents
Advertisement
Reconnect and power on the system
About this task
Complete the following steps to reconnect cables, power on the system, and reconnect a terminal session.
Steps
1. Use the cable labels to reconnect the cables in the same configuration as they were before starting the replacement
procedure.
CAUTION:
When connecting SAS cables to the SAS cards, ensure there is sufficient slack in the cable to
avoid unnecessary strain on the cable connector and the SAS card when the controller is fully extended from
the rack.
2. Close the cable management arms.
3. Prepare the terminal session.
4. Reconnect the AC power cords to the power supplies.
NOTE:
The system may not power on automatically after plugging in the AC power cords.
5. If the system does not power on when the AC power cords were reconnected, press the power button on the right control
panel at the front of the system.
6. When the system boots, log in as sysadmin.
Initializing TPM for BitLocker users
Steps
Initialize the TPM.
82
Replace the Trusted Platform Module (TPM)
Advertisement
Table of Contents
