Suzuki SWIFT 2022 Series Owner's Manual page 30

Press the request switch again after doing
the following:
With the ignition mode changed to LOCK
(OFF) by pressing the engine switch, bring
out the remote controller if it is inside the
vehicle and check that all doors are com-
pletely closed.
Reminder function
EXAMPLE
If the remote controller is not in the vehicle
under the following conditions, the buzzer
sounds intermittently for about 2 seconds
and the immobilizer/keyless push start sys-
tem warning light on the instrument cluster
blinks:
When one or more doors are opened and
all of the doors are later closed with the
ignition in any other mode than LOCK
(OFF).
The indicator light will turn off within sev-
eral seconds after the remote controller is
returned to an area of the vehicle other
than the rear luggage area.
If the remote controller is left in the vehicle
and you lock the driver's door or front pas-
senger's door as described below, the door
will be automatically unlocked.
• If you open the driver's door and lock the
door by turning the lock knob forward or
pushing the power door locking switch,
the driver's door will be automatically
unlocked.
• If you open the front passenger's door
and lock the door by turning the lock
knob forward or pushing the power door
locking switch, the front passenger's
door will be automatically unlocked.
NOTE:
• The reminder will not operate when the
remote controller is on the instrument
panel, in the glove box, in a storage
52RM20610
compartment, in the sun visor or on the
floor, etc.
• Check that the driver always carries the
remote controller.
• Do not leave the remote controller in the
vehicle when leaving the vehicle.
BEFORE DRIVING
Keyless push start system remote con-
troller battery consumption warning
light (Instrument cluster Type A)
If the remote controller becomes unreli-
able, this light appears on the information
display for several seconds when the
engine switch is pressed to change the
ignition mode to ON.
NOTE:
If this light comes on, replace the battery,
and then perform the following operation to
reset the light.
• Lock and unlock the doors with the
remote controller twice or more.
If the power of your spare remote controller
is enough, you can reset the light by oper-
ating above procedure with the spare
remote controller.
70K122
2-10