Suzuki SWIFT 2022 Series Owner's Manual page 202

Emergency stop
In case of emergency, you can stop the
engine by quickly pushing the engine
switch more than 3 times, or pushing and
holding the engine switch for more than 2
seconds while the vehicle is in motion.
NOTE:
Except in cases of emergency, do not stop
the engine while the vehicle is in motion.
The steering and braking operation will
require more effort when the engine is
stopped. Refer to "Braking" in this section.
Master warning indicator light
blinks and engine cannot be started
Your keyless push start system remote
controller may not be sensed as being
within the interior workable area. Try again
after checking that you have the remote
controller with you. If the engine still can-
not be started, the battery of the remote
controller may be discharged. To start the
engine, use the following method:
EXAMPLE
(2)
1) Check that the parking brake is set fully.
2) Manual transmission vehicles:
Shift into "N" (Neutral). Hold the clutch
and brake pedals fully depressed.
Automatic transmission or CVT vehi-
cles:
If the gearshift lever is not in "P" (Park)
position, shift it to "P" (Park). Hold the
brake pedal fully depressed.
3) The "PUSH START SWITCH" message
will appear in the information display in
the instrument cluster. Press the engine
switch (1).
4) The master warning indicator light in
the instrument cluster blinks within
about 10 seconds. Touch the engine
switch with LOCK button side of remote
controller (2) for about 2 seconds.
OPERATING YOUR VEHICLE
NOTE:
• If you still cannot start the engine after
several
method, there may be a problem else-
(1)
where, such as a low lead-acid battery.
Consult a SUZUKI dealer or a qualified
workshop for inspection.
• The immobilizer/keyless push start sys-
tem warning light will come on for about
5 seconds while the master warning indi-
cator light is blinking. In addition, the
information display will show a certain
message during this time. Refer to
"Information display" in "BEFORE DRIV-
ING" section for details.
52RM30020
• You may customize the system to cause
the interior buzzer to sound once for
warning that remote controller is out of
sensing
SUZUKI dealer or a qualified workshop
for the customization.
• If the battery of the remote controller is
about to become completely discharged,
the corresponding message will appear
in the information display when you
press the engine switch to change the
ignition mode to ON. For details on
replacing the battery, refer to "Keyless
push start system remote controller /
keyless entry system transmitter (if
equipped)" in "BEFORE DRIVING" sec-
tion.
attempts using the above
range. Please consult
3-18
a