T7600
INSTRUCTIONS
On/Off Setting: Press
to turn on, press again to turn off, close the fan and valve.
Temperature Setting: Press either
Fan Speed Adjustment: Press
Note: Fan stops at Floor Heating Mode, until FH-FAN parameter set to enable, for single stage floor heating application only.
Delay On/Off setup: Press and hold
then press
or
to adjust the minute by 30 minutes.
Note: Time-On/Off setting performs only once within one day.
Delay On/Off Cancel: Press and hold
delay time, then press
Lock setup: If
Lock function is enabled, the thermostat locks automatically after 30 seconds unused.
Unlock function: Press and hold the
button 5 seconds to unlock instead.
Tio2/ESP Manual: When Tio2/ESP function is set to Manual, press
PARAMETER SETTING (PART 1/2)
Press
and
button for 5 seconds at power off mode to get in parameter list. Press M button to scroll the list and use
parameter value. With model T7603-T000-...JF0 only press
T7600-
T7601-
T7600-
TF21-
TF20-
TF20-
Code
...JS0
...JS0
...JS0
■
■
■
01
■
■
■
02
■
■
■
03
■
■
■
04
■
■
■
05
■
■
■
06
■
■
■
07
■
■
■
08
■
■
■
09
■
10
---
---
...Continued...
P/N 24-85784-00151 Rev. F Issue Date: 10 2020
or
button to increase or decrease the temperature by 0.5°C/1°F.
to switch the fan mode, auto
button 5 seconds, then "ON" appears, press
button 5 seconds, then "ON" appears, press
or
adjust the time to "00:00".
button 5 seconds to unlock. T7603-T000-...JF0 has no
to get parameter list and
T7603-
T7600-
T000-
TB21-
...JF0
...JA0
Parameter Name
■
■
Upper setpoint limit
■
■
Lower setpoint limit
---
---
Application
Cooling setpoint
■
---
unoccupied
Heating setpoint
■
■
unoccupied
■
■
Frost protection
■
■
Frost protection setpoint
Fan speed in AUTO
mode in dead band (room
■
---
temperature reach set
point)
Fan mode when
■
---
unoccupied
---
---
ECM Min voltage
flash, high
, medium
button to switch On or Off delay,
button to switch to check On or Off
button once, to switch Tio2/ESP On or Off.
to scroll the list.
Default Function
35°C
Setting range 2°C to 40°C (36°F to 99°F)
5°C
Setting range 0°C to 38°C (32°F to 95°F)
T7601-TF20-...JS0 with EC Motor Control
00: 2-pipe ON/OFF valve
01: 4-pipe ON/OFF Valve
02: 2-pipe ON/OFF 3-wire relay valve
03: 2-pipe ON/OFF valve with TiO2/ESP relay
04: 2-pipe ON/OFF valve with floor heating
05: Water source heat pump
06: 2-pipe Proportional valve
T7600-TF21-...JS0 Proportional Control
00
00: 2-pipe Proportional valve
01: 4-pipe Proportional valve
T7600-TF20-...JS0 ON/OFF Control
00: 2-pipe ON/OFF valve
01: 4-pipe ON/OFF Valve
02: 2-pipe ON/OFF 3-wire relay valve
03: 2-pipe ON/OFF valve with TiO2/ESP relay
04: 2-pipe ON/OFF valve with floor heating
05: Water source heat pump
26°C
Setting range 22°C to 32°C (72°F to 90°F)
18°C
Setting range 10°C to 21°C (50°F to 70°F)
00: On
00
01: Off
5°C
Setting range 0°C to 20°C (32°F to 68°F)
00: Fan off
01
01: Low speed
00: Low speed
00
01: Set speeds
Min voltage below which the fan output is 0%,
3V
range 0 V-10 V. The adjustment is 0.5V for every step..
English
, low
fan.
button, press and hold the
and
button to change