Clarion XDZ616w Owner's Manual page 23

Manual memory
The main unit has a manual memory function
for DAB programmes. Up to 18 programmes
(6 programmes each) can be preset in the pre-
set buttons.
[M1], [M2] and [M3]
1. Press FNC button 3 to select DAB mode.
2. Press BND button ! to select any one shown
above.
3. Press the right or left SEARCH button % to
select a desired programme.
4. Press and hold one of Preset buttons (1 to 6) 8
for 2 seconds or longer to store the programme.
Note:
• The interrupt programme (PTY or INFO) cannot
be written into a manual memory.
Recalling a preset programme
1. Press FNC button 3 to select DAB mode.
2. Press BND button !. Each time you press
BND button !, the display changes in the fol-
lowing order:
[M1] [M2] [M3]
3. Press one of Preset buttons 8 to recall a
preset programme.
Note:
• Press and hold Preset button 8 for 2 seconds or
longer to store the programme currently being re-
ceived. (Manual memory)
AF function
The AF function switches to a different frequency
on the same network in order to maintain opti-
mum reception.
The factory default setting is "ON"
If the reception of the current broadcast station
deteriorates, "SEARCHING FOR SAME STATION"
or "SEARCH" appears in the display and the radio
searches for the same programme on another fre-
quency.
For details on "AF function", refer to the section
"RDS operation" of each owner's manual.
Switching OFF the AF function
Switching ON the AF function
AF function between RDS and DAB
When the same programme is broadcast by both
RDS and DAB, and this function is ON, the main
unit switches to receiving the broadcast with the
better reception automatically.
[M1]...
Digital Radio / DAB Operations
TA (Traffic Announcement)
In TA standby mode, when a traffic announcement
broadcast starts, the traffic announcement broad-
cast is received as top priority regardless of the
function mode. Traffic programme (TP) automatic
tuning is also possible.
This function can only be used when "TP" is lit in
the display. When "TP" is lit, this means that the
DAB or RDS broadcast station being received has
traffic announcement programmes.
For details on "TA", refer to the section "RDS op-
eration" of each owner's manual.
Setting TA standby mode
Cancelling TA standby mode
Searching for a TP station
Notes:
• If a TP station is not received, the main unit stops
the search operation.
• "TP" may be lit in the display when a TP broadcast
is transmitted from an RDS station. In this case,
press ISR button 9 to perform TP seek tuning.
Press ISR button 9 again to return to the previ-
ous mode.
INFO (Announcement)
In INFO standby mode, when the selected
announcement programme starts, the main unit
switches to the selected announcement
programme automatically.
Setting INFO standby mode
If you press and hold ISR button 9 for 1 second
or longer, "INFO" lights in the display and the main
unit is set into INFO standby mode until the se-
lected announcement is broadcast. When the
selected announcement broadcast starts, the
announcement item appears in the display. If you
press and hold ISR button 9 for 1 second or
longer while the selected announcement broad-
cast is being received, the selected announce-
ment broadcast reception is cancelled and the
main unit goes into INFO standby mode.
Cancelling INFO standby mode
To cancel INFO standby mode, press and hold
ISR button 9 for 1 second or longer.
27
XDZ616