Tools Required - Raymarine Realvision RV-220P Installation Instructions Manual

3d bronze through-hull transducer
Table of Contents

Advertisement

Tools required

The following tools are required to install any of the transducers listed under "Applicable products".
1
Power drill
2
62 mm / 2⅜ inch hole cutter
3
Drill bit (suitable size for drilling pilot holes)
4
9 mm / ⅜ inch drill bit (for drilling anti-rotation bolt hole)
5
Half round file
6
75 mm / 3 inch wrench (spanner) or suitable size adjustable wrench (spanner)
7
Marine grade sealant (non-acetate based)
8
Adhesive tape
Warning: Marine-grade sealant
Only use marine-grade neutral cure polyurethane sealants. Do NOT use sealants
containing acetate or silicone, which can cause damage to plastic parts.
6

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents