Table of Contents
Advertisement
7.1 Tools required
The following tools are required for installation.
1.
Cordless drill.
2. Pozi-drive screw driver.
3. Suitable sized drill bit for mounting the Wind transducer.
4. Suitable sized drill bit for mounting the Gateway.
5. 5 mm (
13
⁄
in) drill bit (for mast cable routing).
64
6. Wire cutters.
7.
3 mm A/F hex wrench (Allen key) (for extra tightening of thumb screw).
8. Pencil or marker.
Note:
Drill bit sizes for mounting holes must be a suitable size for the fixings
and the material type and thickness of the mounting surface.(e.g.: a 4 mm
(
5
⁄
in) drill bit should be used when mounting the wind transducer on an
32
aluminium surface).
Installation
7.2 Mast cable routing
The mast cable can be either routed inside or along the outside of the mast.
When routing the cable inside the mast, the mast cable exit can be located
under the mounting plate. The mounting plate includes a cable recess for
this purpose.
To keep the size of any holes that need to be drilled for cable routing to a
minimum, route the mast cable from the transducer location using the bare
wire end first.
• Ensure sufficient slack at the transducer end so that the wind transducer
can be disconnected if necessary
• When drilling routing holes ensure they are large enough for the mast
cable which has an approximately diameter of 5 mm (0.20 in).
• The cable should be secured at regular intervals using cable clips.
• Excess cable can be cut once the cable has been routed to the gateway.
1.
RSW-Wired Smart wind transducer.
2. Cable routing externally.
3. Cable routing internally.
23
Advertisement
Table of Contents
Troubleshooting
