Applicable Products - Raymarine Realvision RV-220P Installation Instructions Manual

Applicable products

This document is applicable to the RV-200, RV-212(P/S), and RV-220(P/S) RealVision™ 3D bronze
thru-hull transducers.
These transducers are capable of producing 3D sonar images when connected to RealVision™ 3D
variant MFDs running LightHouse™ 3 software. Five transducers are available in the RV-2xx series,
each having the same external shape and dimensions.
The transducers differ internally, and contain different numbers and types of transmit and receive
elements. Your installation should comprise either a single RV-200 transducer, or a split-pair of
RV-212(P/S) or RV-220(P/S) transducers.
The hull geometry of your vessel determines the most appropriate transducers to use. You should
fit transducers whose internal elements are matched to within ±6° of your hull's deadrise angle, as
shown in the following table:
Model Part
no. no. Description
RV-20 A804 RealVision™ 3D Bronze Thru-Hull
0 65 Transducer, 0°, single ("all in one")
RV-21 A804 RealVision™ 3D Bronze Thru-Hull
2P 66 Transducer, 12°, split-pair
RV-21 A804
2S 67
RV-22 A804 RealVision™ 3D Bronze Thru-Hull
0P 68 Transducer, 20°, split-pair
RV-22 A804
0S 69
• Bronze thru-hull transducers are recommended for fiberglass and wooden hulls and should
not be used on a metal hull.
• Do NOT install bronze transducers on vessels with a positive ground system.
Important: This installation sheet is applicable to the bronze-construction RV-2xx–series thru-hull
transducers only. For RV-3xx–series plastic-construction thru-hull transducers, refer to the
separate installation sheet.
Hull geometry
Hull with 0° (flat-bottom) to 6° deadrise
angle.
Hull with 6° to 18° deadrise angle, port
side
(pair with A80467 below)
Hull with 6° to 18° deadrise angle,
starboard side
(pair with A80466 above)
Hull with 14° to 26° deadrise angle, port
side
(pair with A80469 below)
Hull with 14° to 26° deadrise angle,
starboard side
(pair with A80468 above)
5