3.1 Tools required
The following tools are required to install your transducer:
1.
Power drill
2. 4 mm hex wrench (Allen key)
3. 5 mm hex wrench (Allen key)
4. Pozi-drive screw driver
5. Drill bit (suitable for pilot holes)
6. Marine grade sealant
7.
24 mm (15/16 in) or suitable size hole cutter (only required when routing the cable through a
bulkhead or transom)
8. Masking / adhesive tape
Warning: Marine-grade sealant
Only use marine-grade neutral cure polyurethane sealants. Do NOT use sealants
containing acetate or silicone, which can cause damage to plastic parts.
16