Replacement Of Major Parts - Panasonic AG-DV2500P Service Manual

No. Item
2.6

REPLACEMENT OF MAJOR PARTS

! The disassembly procedures shown in oder of disassembly. To remove the part, it is necessary to have completed all the stages
before it.
! Always use a torque driver and the specified securing torque to tighten screws.
! Position the mechanism to the unloading end (No Cassette) mode before disassembly or assembly unless otherwise specified.
ı
1 Cassette housing assembly
Cassette housing assembly Manually perform
the loading operation so that the cassette holder
bar comes on the position of this screw.
Cassette
holder bar
Cassette
holder
Hook
3
Look lever
1
2 Head cleaner assembly/
( S3 )
3
( S3 )
Drum assembly
2-8
Ref. Illustration
( S1 )
2
Hook
Fig. 2.6.1
2
Drum assembly
( S2 )
2
1
( S3 )
Head cleaner assembly
Fig. 2.6.2
<Disassembly>
1)Turn the cassette housing motor emergency gear
Hold this part
in the direction of the arrow, while pushing the lock
when removing
or attaching lever in the direction of arrow 2, then move the
the assembly.
cassette holder so that the cassette holder bar
comes in the position shown in the illustration.
( S1 )
2)Remove two screws (S1), slide the cassette hous-
ing toward the front and remove it by releasing the
1
lock on the Hook function as shown by arrow 3.
Cassette
<Assembly>
Housing
1)Reverse the disassembly procedure.
Motor
Emergency
2)Screws (S1) should be tightened using a securing
Gear
torque of 0.2 N/m (2 kgf/cm).
Note:
3
Be sure to attach the cassette housing in the
same position as when it was removed.
<Disassembly>
Head cleaner assembly:
1) Remove the screw (S2) and remove the head
cleaner assembly.
Drum assembly:
1) Remove the Drum FPC from the DV/CPU circuit
board CN107.
2) Remove the screw (S3) and remove the drum as-
sembly.
<Assembly>
1) Reverse the disassembly procedure.
2) Drum section screws (S3) should be tightened in
order of
0.04 N/m (0.4 kgf/cm).
Procedure
(OK) (NG)
Hook function of the Cassette hausing.
1 3
— and using a securing torque of