Assembly And Setup; Base Support Extension - Jet JWBS-16B Operating Instructions And Parts Manual

Assembly and Setup

Base Support Extension

1. Attach straps (A, Fig. 1A) to extension base (B,
Fig. 1A) with (2) 5/16-18 button head cap
screws (C, Fig. 1A) and with (2) 5/16 flat
washers (D, Fig. 1A). If needed punch holes
through striping decal. NOTE: Leave screws
slightly loose.
2. Repeat for opposite end of extension base.
3. Insert straps through slits in base of machine
lining up holes in machine base with tapped
holes in strap (Fig 1B)
4. Attach straps to machine base using (2) 5/16-
18 button head Cap screw (E, Fig. 1C) and (2)
5/16 flat washers (F, Fig. 1C).
5. Repeat for opposite end of extension base.
6. Tighten all (8) button head cap screws with the
5 MM hex wrench provided.
7. Attach the handle (C, Fig. 2) to the hand wheel
(D, Fig. 2).
Figure 1A
Figure 1B
Figure 1C
9