Example: Center Unit + Dvd Changer + Monitor - Clarion DVC920 Owner's Manual

Example : Center Unit + DVD Changer + Monitor
I When this control unit is connected, a 5.1ch surround decoder can be
controlled, even when used with a center unit equipped with RCA 2ch
audio outputs. This also makes it possible to adopt digital wiring con-
nections for a DVD changer.
CeNET DVD Changer
(Gray)
Optical Digital cable (sold separately)
DCA-005 (5 m) DCA-008 (1.5 m)
* Connect properly in accordance with
color of connectors
5.1ch surround
(DVH920)
(Black)
Audio signal
output connector
Center unit
Set the 5.1ch surround
decoder's [STAND-ALONE /
SLAVE] switch to the [STAND-
ALONE] position.
SLAVE
NOTES:
• Be sure to set the DVD changer's [CeNET/STAND-ALONE]
switch to the [STAND-ALONE] position.
• Do not use the DVD changer's RCA audio output (AUDIO OUT)
jacks.
18
DVC920
280-7804-00_09-18(En)
(VCZ625)
RCA video cable (yellow);
(furnished with DVD changer)
RCA pin cable
(sold separately)
decoder
Analog
signal
input
connectors
STAND
ALONE
18
5.1ch surround
decoder control unit
(DVC 920)
SOURCE A-MODE ADJUST D S F POWER
4CH power amplifier
Speaker wire
Front speakers
Powered center speaker
RCA pin cable
(furnished with center speaker)
Powered sub-woofer
Built-in amplifier
RCA pin cable
(sold separately)
2/22/02, 2:07 PM
Monitor
Rear speakers
Built-in amplifier
Amplifier
280-7804-00