Example: Center Unit + Dvd Changer + Monitor - Clarion DVC920 Owner's Manual

Example : Center Unit + DVD Changer + Monitor
I When this control unit is connected, a 5.1ch surround decoder can be
controlled, even when used with a center unit equipped with RCA 2ch
audio outputs. This also makes it possible to adopt digital wiring con-
nections for a DVD changer.
CeNET DVD Changer
(Gray)
Optical Digital cable (sold separately)
DCA-005 (5 m) DCA-008 (1.5 m)
* Connect properly in accordance with
color of connectors
5.1ch surround
(DVH920)
(Black)
Audio signal
output connector
Center unit
Set the 5.1ch surround
decoder's [STAND-ALONE /
SLAVE] switch to the [STAND-
ALONE] position.
SLAVE
NOTES:
• Be sure to set the DVD changer's [CeNET/STAND-ALONE]
switch to the [STAND-ALONE] position.
• Do not use the DVD changer's RCA audio output (AUDIO OUT)
jacks.
(VCZ625)
decoder
Analog
signal
input
connectors
STAND
ALONE
RCA video cable (yellow);
(furnished with DVD changer)
5.1ch surround
decoder control unit
(DVC 920)
SOURCE A-MODE ADJUST D S F POWER
RCA pin cable
(sold separately)
Speaker wire
Front speakers
RCA pin cable
(furnished with center speaker)
RCA pin cable
(sold separately)
Monitor
4CH power amplifier
Rear speakers
Powered center speaker
Built-in amplifier
Amplifier
Powered sub-woofer
Built-in amplifier