Epson WF-2930 Start Here

WF-2930/WF-2950
Start Here
IMPORTANT: Before using this product, make sure you read
these instructions and the safety instructions in the online
User's Guide.
This printer is designed for use with Epson
Note:
third-party cartridges or ink. For important ink information, visit
http://epson.com/epsonink (U.S.) or http://epson.ca/epsonink
(Canada) or see your printer box.
Important Safety Instructions:
should always follow basic safety precautions to reduce the risk of fire,
electric shock, and personal injury, including the following:
• Do not use the Epson product near water.
• Always keep this guide handy.
• Avoid using a telephone during an electrical storm. There may be a
remote risk of electric shock from lightning.
• Do not use a telephone to report a gas leak in the vicinity of the leak.
To reduce the risk of fire, use only a No. 26 AWG or larger
Caution:
telecommunication line cord.
The illustrations show the WF-2950, but the steps are the same
for the WF-2930, unless otherwise specified.
Unpack
1
Do not open the ink cartridge packages until you are ready to
Note:
install the ink. Cartridges are vacuum packed to maintain reliability.
1
Remove all protective materials from the product and lift
up the scanner unit until it locks into place.
2
Remove all protective materials from inside the product.
Do not touch the flat white cable.
Caution:
cartridges only, not
®
When using telephone equipment, you
3
Lower the scanner unit: Lift the scanner unit up slightly
and lower it. When the scanner unit catches, lift it up
again and lower it completely.
The scanner unit must be lowered completely before it can
Note:
be opened again.
4
Connect the power cord to the back of the product and to
an electrical outlet.
Do not connect to your computer yet.
Caution:
2
Choose a setup method
The Epson Smart Panel app can help you set up your printer
®
through an interactive, step-by-step process using your
smartphone or tablet.
To use your mobile device
for setup, continue to
step 1.
1
Download the Epson Smart Panel app
from your device's app store. Do not
launch the app yet.
2
Hold the power button until it lights up to turn on the
product.
Do not connect your product to your computer yet.
Note:
3
Launch the app and follow its instructions to set up your
product. If necessary, tap the
corner of the app's home screen, tap Start setting up,
and follow the instructions to set up your product.
For information on connecting your product to a computer,
using voice-activated printing, or solving problems, or for
details on reaching Epson support, see the sections on the
back of this sheet.
OR
If you do not want to use
a mobile device for setup,
skip to the "Turn on and
configure" section.
+
icon on the top right