Advertisement
To connect to audio equipment with a digital input
You can enhance the sound quality by connecting the unit's DIGITAL OUT to the digital input of an amplifier, DAT or
MD by using an optional digital cable. The digital audio signal from a disc is directly transferred. If you connect the
unit to a Dolby Digital or DTS decoder or an amplifier with a built-in decoder by using an optional digital cable, you
can enjoy high-quality surround sound.
When you make the digital connection, also make the analog connection, because, depending on the disc type, no
audio may be reproduced from the DIGITAL OUT.
The unit
VIDEO OUT
VIDEO
S-VIDEO
COMPONENT
Y
P
B
AV COMPU LINK
AUDIO OUT
LEFT
COAXIAL
RIGHT
Red
White
NOTES
• When you connect the unit's DIGITAL OUT to digital audio equipment, before using, make the "DIGITAL AUDIO OUTPUT"
setting in the "AUDIO" page of the preference display correctly according to the connected audio equipment. If the "DIGITAL
AUDIO OUTPUT" is not set correctly, loud noise may be generated from speakers, causing damage to your speakers. See
"DIGITAL AUDIO OUTPUT" on page 37.
• With the digital connection, the unit's settings for COMPRESSION and DOWN MIX in the AUDIO page of the preference display
are invalid. Settings for these items must be made from the decoder.
To connect the power cord
When all the audio/video connections have been made, insert the smaller plug of the supplied AC power cord to the
unit's AC IN connector, then insert the other end to the wall outlet. Make sure that plugs are inserted firmly. The
STANDBY indicator lights and setup is completed.
Warning
• Disconnect the power cord if you are not going to use the unit for a long time.
• Disconnect the power cord before cleaning the unit.
• Disconnect the power cord before moving the unit.
• Do not connect or disconnect the power cord with wet hands.
• Do not pull the power cord when disconnecting it, as this may damage the cord and cause fire, electric shock, or
other accidents.
Caution
• Do not damage, alter, twist, or pull the power cord, as this may cause fire, electric shock, or other accidents.
• To prevent any accidents or damages caused by an unsuitable AC power cord, only use the supplied power cord. If
the cord is damaged, contact a dealer and get the new power cord.
• Do not put anything heavy, or the unit, on the power cord, as this may cause fire, electric shock, or other accidents.
P
R
DIGITAL OUT
PCM / STREAM
OPTICAL
Coaxial digital cable
(not supplied)
Audio cable
(not supplied)
When using the DIGITAL OUT
(OPTICAL) jack, remove the protection
cap. Do not lose the removed cap.
When the jack is not used, fix the
protection cap into the jack.
Optical digital cable
(not supplied)
Digital equipment
IN
White
LEFT
RIGHT
Red
Getting started
IN
OPTICAL
AUDIO
DIGITAL
COAXIAL
English
Français
14
Advertisement
