Table of Contents
Advertisement
3.0 Programming
3.1 Transmitter Programming
To change the RF channel of the RF450V transmitter:
1.
2. Once the channel light is flashing release the program button.
3. A single press on the program switch will change the RF channel by one.
4. To save the new channel, hold down the program switch for 3 seconds until the
At any point you wish to exit programming mode without saving the new settings, hold
down the tamper switch until all LED's extinguish.
3.2 Receiver Programming
To enter program mode follow the steps below:
1.
2. While the yellow LED's are flashing, either the power or input LED will flash too. The
3. To program the selected option hold down the program switch for 1 second, and the
4. If "Program RF Channel" has been selected, the power LED and one of the seven status
5. To save the current channel hold down the program switch for 3 seconds. If the two
6
Hold down the program switch for 3 seconds until the channel light starts flashing.
channel LED stops flashing.
Hold down the program switch for 3 seconds until the yellow LED's start to flash, then
release the program switch.
power LED indicates "Program RF Channel" and the input LED indicates "Program Out-
put Timer". Briefly pressing the program switch toggles between these two modes.
green LED's will flash twice to indicate the mode has been selected. Depending which
option has been selected follow options 4 or 6.
LED's will flash to indicate the current RF channel. To change the RF Channel, briefly
press the program switch. If a RF450V transmitter has been found the RF channel LED
emits one long pulse followed by two short pulses. If no transmitter has been found the
RF LED emits only one long pulse.
green LED's flash twice a valid RF450V transmitter has been saved and paired, but if the
two RED LED's flash twice only the RF channel has been saved (no transmitter found).
Advertisement
Table of Contents
