Receiver Signal / Status Led's - Genie RF450V User Manual

5.0 Receiver Signal / Status LED's

The RF450V signal / status LED's have a few meanings. While the RF450V is not in
programming mode by briefly pressing the programming switch selects one of three
options.
1.
2. Transmitter status. This mode displays the status of the received transmitter. The table
3. Display currently selected RF channel. In this mode only 1 LED will flash. This LED is the
If options 2 or 3 are left selected for more then 1 minute then the RF450V will default back
to the signal strength mode.
10
Signal strength (default), this mode displays the signal level being received from the
transmitter. We recommend 2 ~ 3 bars of signal for a reliable link.
below shows the LED meanings (Note: If a transmitter is not paired video and audio will
be present but the input and tamper channels will not work).
currently selected RF channel. To change the RF channel refer to the programming
section. Briefly pressing the program switch again returns back the signal strength
mode.