Introduction - Genie RF450V User Manual

1.0 Introduction

Please read this instruction carefully before operating the product and keep it for further
reference. All examples and pictures used here are for reference only.
The contents of this manual are subject to change without notice.
The Genie RF450V is a high quality 7 channel 5.8GHz audio / video wireless interface.
Designed for the CCTV industry the RF450V is enclosed in a small IP65 rated enclosure, has
a built in signal strength meter, status indicator, directional patch antennas and two digital
inputs for an external input and a tamper circuit.
The tamper circuit monitors lid removal for both the transmitter and receiver, an external
tamper input to the transmitter and it also detects the loss of a paired transmitter; either
through power failure or signal jamming.
The transmitter's digital input channel has been designed for a connection to a PIR or door
contact etc, the signal is then transmitted to the receiver and output via a set of volt free
contacts. The volt free output can also be programmed with a timer period from 1 second
to 30 minutes, which is activated after the input has switched off. A typical use for this
could be a control signal to drive external lighting.
The RF450V incorporates a very simple programming system were a single switch allows
the RF channel to be changed, pairing of a transmitter to a receiver, programming of the
output timer and selection of the status monitor. Connections to both the transmitter
and receiver are via a 10-way rising clamp connector for the power, audio / video signals,
digital tamper and input / output channels.
Both the transmitter and receiver are supplied with a robust wall / pole (additional U bolts
required) mounting bracket to allow X and Y movement. When used in conjunction with the
internal 7 bar signal strength meter, reliable links can be achieved.
3