Insert Editing; Random Assemble Editing [R.a.edit] - JVC GR-D201US Instructions Manual

$ $ $ $
   
EN EN EN EN

Insert Editing

You can record a new scene into a previously
recorded tape, replacing a section of the original
recording with minimal picture distortion at the in
and outpoints. The original audio remains
unchanged.
START/STOP
PAUSE
REW
PLAY
INSERT
STOP
T
RM-V718U (provided)
W
REW
STOP
NOTES:
Before performing the following steps, make sure
that "TIME CODE" is set to "ON". (
Insert Editing is not possible on a tape recorded in
the LP mode or on a blank portion of a tape.
To perform Insert Editing while watching in the
television, make connections. (
1
Play back the tape, locate the Edit-Out point and
press PAUSE (9). Confirm the time code at this
point. ( pg. 41)
2
Press REW (3) until the Edit-In point is located,
then press PAUSE (9).
3
Press and hold INSERT (I) on the remote
control, then press PAUSE (9). The "9I"
indicator and the Time Code (min.:sec.) appear
and the camcorder enters Insert-Pause mode.
4
Press START/STOP to begin editing.
Confirm the insert at the time code you
checked in step 1.
To pause editing, press START/STOP. Press it
again to resume editing.
5
To end Insert Editing, press START/STOP, then
STOP (8).
NOTES:
Program AE with special effects (
used to spice up the scenes being edited during
Insert Editing.
During Insert Editing, the date and time
information changes.
START/STOP
INSERT
PLAY
PAUSE
RM-V717U (optional)
pg. 31, 41)
pg. 22)
pg. 33) can be
USING THE REMOTE CONTROL UNIT (cont.)
If you perform Insert Editing onto a blank space on
the tape, the audio and video may be disrupted.
Make sure you only edit recorded areas.
During Insert Editing, when the tape moves to
scenes recorded in the LP mode or a blank
portion, Insert Edting stops. (
If a memory card is loaded and "NAVIGATION" is
set to other than "MANUAL", a NAVIGATION
thumbnail image is stored in the memory card.
( pg. 48)
Random Assemble Editing
[R.A.Edit]
Create edited videos easily using your camcorder as
the source player. You can select up to 8 "cuts" for
automatic editing, in any order you like. R.A.Edit is
more easily performed when the MBR (Multi-Brand
Remote) is set to operate with your brand of VCR
(see "VCR CODE LIST"), but can also be performed
by operating the VCR manually.
To perform Random Assemble Editing, use the
optional RM-V717KITU remote control kit.
Before operation, make sure the batteries are
installed in the remote control. (
pg. 84, 85)
pg. 56)
SHIFT
MBR SET
RM-V717U (optional)