Initializing A Memory Card - JVC GR-D201US Instructions Manual

! ! ! !
   
EN EN EN EN
To Print By Selecting Still Images And Number
Of Prints
1
Perform steps 1 – 8 in "To Print All Still Images
(One Print For Each)" (
2
Press + or – to select
"CURRENT", and press
SELECT/SET. The DPOF
screen appears.
3
Press REW (3) or FF
(5) to select the desired
file.
4
Press + or – to select the number indication (00),
and press SELECT/SET.
5
Select the number of prints
by pressing + to increase
number, or – to decrease
the number, and press
SELECT/SET.
Repeat steps 3 through 5
for the desired number
of prints.
The number of prints can be set up to 15.
To correct the number of prints, select the
image again and change the number.
6
Press + or – to select
"RETURN", and press
SELECT/SET. The "SAVE?"
appears.
If you did not change
any settings in step 3
through 5, the Menu
Screen reappears.
7
Press + or – to select "EXECUTE" to save the
setting you have just made, and press SELECT/
SET.
To cancel selection, select "CANCEL".
To Reset The Number Of Prints
1
Perform steps 1 – 8 in "To Print All Still Images
(One Print For Each)" (
2
Press + or – to select "RESET", and press SELECT/
SET. The DPOF screen appears.
3
Press + or – to select "EXECUTE", and press
SELECT/SET. The normal playback screen
appears.
To cancel selection, select "RETURN".
The number of prints is reset to 0 for all still
images.
CAUTION:
While performing the above, never disconnect
power, as this may cause the memory card to be
corrupted.
pg. 29).
DPOF
SHEETS
0 0
RETURN
DPOF
SHEETS
0 5
DPOF
SAVE?
EXECUTE
CANCEL
pg. 29).
D.S.C. PLAYBACK (cont.)

Initializing A Memory Card

You can initialize a memory card anytime.
After initializing, all files and data stored in the
memory card, including those which have been
protected, are cleared.
1
Set the VIDEO/MEMORY Switch to "MEMORY".
2
Set the Power Switch to "PLAY" while pressing
down the Lock Button located on the switch.
3
Open the LCD monitor fully, or pull out the
viewfinder fully.
4
Press MENU. The Menu
Screen appears.
5
Press + or – to select
"FORMAT", and press
SELECT/SET. The FORMAT
screen appears.
6
Press + or – to select
"EXECUTE", and press
SELECT/SET. The memory
card is initialized.
When initialization is finished, "NO IMAGES
STORED" or "NO E-MAIL CLIP STORED"
appears.
To cancel initialization, select "RETURN".
CAUTION:
Do not perform any other operation (such as
turning off the camcorder) during initialization.
Also, be sure to use the provided AC Adapter, as
the memory card may be corrupted if the battery
becomes exhausted during initialization. If the
memory card becomes corrupted initialize it.
MENU
PROTECT
DELETE
DPOF
NO . RESET
FORMAT
D I SPLAY
END
F ORMAT
ERASE AL L
EX I ST I NG DATA?
EXECUTE
RETURN