Test 5 - Phone Testing Using A Test Call - Agilent Technologies Agilent E6474A User Manual

Test 5 - Phone testing using a test call

Agilent E6474A User's Guide
Setting up the hardware
1 Connect the system components per the instructions in
Chapter 3.
2 Power the system on. Allow 30 minutes for the system to
stabilize before testing.
3 If the system is equipped with a GPS/DR Navigation unit,
move the vehicle approximately 10 feet.
Testing the signal
1 Start the E6474A software.
2 Refer to "Identifying devices"
procedure if you have not already done so.
3 Verify that the navigator is enabled in the System Setup view.
4 Click Log > Start Logging.
5 Open the Route Map view.
Passing the test
If the status area of the Route Map view reports the same
longitude and latitude of your current location, the GPS is ready
for use. If the navigator is not communicating, a dialog box with
an error message appears.
If you experience problems in setting up the test, refer to
"Troubleshooting your E6474A system"
Setting Up the hardware
1 Connect the system components per the instructions in
Chapter 3.
2 Power the system on.
Get Assistance, if You Need It
on page 81, and perform the
on page 102.
6
117