Connecting To A Converter; Selecting And Connecting The Cables - Siemens SIMOTICS S-1FK2 Configuration Manual

More precise information on the angle of rotation is available in Chapter "Rotating the connector
on the motor (Page 138)"
8.3.4

Connecting to a converter

8.3.4.1

Selecting and connecting the cables

• Use prefabricated MOTION CONNECT cables from SIEMENS or shielded connecting cables.
The appropriate cables for your motor are listed in the Chapter "Motor overview / Assignment
Motor modules / Power cables (Page 85)".
• The prefabricated MOTION CONNECT cables reduce installation costs and increase the
operational reliability
Note
The cable shielding, made up of as many strands as possible, must have a high electrical
conductivity. Braided shields made of copper or aluminum are well suited.
When connecting, comply with the following:
• Connect the shield to the converter.
• Keep the unshielded cable ends as short as possible.
• Apply the contact over a large area for a good dissipation of the high-frequency currents.
1FK2 Synchronous Motors for SINAMICS S120
Configuration Manual, 02/2022, A5E46927724B AD
Electrical connection
8.3 System integration
141