Easycoder Pm4I Printers - Intermec EasyCoder PF2i Installation Instructions Manual

Chapter  — Physical Installation

EasyCoder PM4i Printers

Using a #T20 Torx screwdriver, loosen the four screws that holds the
4
cover along the lower left edge of the bottom plate.
Remove the four screws that hold the cover to the center section.
5
Pull out the cover so you can disconnect the console cable from the
6
CPU board.
Put the cover aside on a soft cloth or similar to avoid scratches.
7
Remove any present EasyLAN Ethernet interface including cables etc.
8
Fit the RJ-45 plug included in the kit into the square hole left by the
RJ-45 Ethernet connector.
Remove the antenna plug, which is snap-locked into the rear plate.
9
 EasyLAN Wireless Interface Kit Installation Instructions