About These Instructions; Printer Firmware; Installation Kit - Intermec EasyCoder PF2i Installation Instructions Manual

Chapter  — Introduction

About These Instructions

These instructions describe how to install an EasyLAN Wireless network
interface in an EasyCoder PF2i, PF4i, PF4i Compact Industrial, PM4i,
PX4i, or PX6i printer and how to connect it to a LAN, WAN, Intranet,
or Internet network via a wireless connection.
The installation instructions describe how to physically install the
interface board in a printer and how to set up the IP address, subnet
mask, default router, and name server. The instructions end when you
have the printer's home page up and running. From there, please refer to
the Intermec EasyLAN User's Guide on the included CD.
This interface kit must only be installed by an authorized
service technician. The device is country/region specific
and must be ordered for the correct country/region. Use of
this device in other region than shown on the device home
page/test label may violate applicable law.

Printer Firmware

The printer must be running either Intermec Fingerprint v8.40 (or later)
or IPL v2.40 (or later). In Intermec Fingerprint, the network port is
addressed as device "net1:" (communication channel #5).

Installation Kit

The EasyLAN Interface Kit contains:
• One EasyLAN adapter board complete with radio module fitted
• Rear plate (for EasyCoder PF2/4i-series printers only)
• RJ-45 plug (for EasyCoder PM4i- and PX4/6i series printers only)
• One light guide
• One hexagonal threaded spacer
• One antenna extension cable
• One antenna
• One cable clip
• One cable tie
• One CD with software and manuals
• This Installation Instruction booklet
The only tools required for the installation are #T10 and #T20 Torx
screwdrivers and a small wrench.
 EasyLAN Wireless Interface Kit Installation Instructions