Loading Roll Media - Intermec EasyCoder 4420 User Manual

Chapter 1 — Getting Started
8
C d 39

Loading Roll Media

1 Raise the printhead by rotating the head lift lever clockwise until the
printhead disengages.
2 Turn the supply roll retainer counterclockwise to release it and then
slide it to the outer end of the supply roll post. Turn it clockwise to lock
it in place.
Note: If you are replacing the empty media roll with a new roll of the
same width, you do not need to adjust the edge guide or the supply roll
retainer.
3 Place the media roll on the supply roll post and position it firmly against
the printer.
4 Insert the media support between the roll of media and the supply roll
retainer before securing it.
5 Turn the supply roll retainer counterclockwise and slide it lightly up
against the media support. Turn the supply roll retainer clockwise to
secure.
6 Loosen the edge guide and slide it all the way to the outer edge of the
lower media guide. Tighten it in place.
7 Pull down on the lower media guide to allow easy access to the media
path.
8 Unroll several inches of media and insert it between the media guide
plates as shown below. Make sure the label passes between the upper
and lower media guides and out the front of the printer.
Head lift
lever
Media
Label
gap
sensor
Edge
guide
EasyCoder 4420 and 4440 Bar Code Label Printer User's Manual
Helvetica Condensed Helvetica
Upper
media guide
Lower
44XXU027.eps
media guide
Media roll
Supply roll
post
Supply roll
retainer
Media
support